Assembling Predator Ghillie™ Back Panel Cover
Assembling the Beez Combat Systems Predator Ghillie™ Back Panel Cover is extremely easy and can take less than ten minutes if done right. Begin by separating the predator dreads from the back panel cover. There should be a total of eight predator dreads. Once removed take the bungee retention cord and singe both ends of it with a lighter. This makes weaving of the bungee retention cord easier throughout the assembly process.
Next, identify the front of the Predator Ghillie™ Back Panel Cover by the ” V ” shape laser cut slit. Weave the bungee retention through this laser cut slit through the bottom so that the bungee retention is mostly concealed. Begin weaving the bungee retention to each corner keeping the length of the cord even at all times. Once the corners are reached begin weaving the bungee retention cord up each side in a ” S ” like fashion.
While weaving each side of the bungee retention cord ensure that the cord is at an even length between each side at all times. Doing so will allow the Predator Ghillie™ Back Panel Cover to begin to properly take shape. Continue weaving the bungee retention cord in an ” S ” like fashion until the last two corners are met. Once these two corners are met weave the bungee retention cord towards itself until both ends meet. Slide each end through the material so that the ends meet beneath the material allowing for the most concealment. Once met, simply tie an overhand knot and begin adjusting the material around the bungee retention cord so that the back panel cover is even.
Attach the Predator Ghillie™ Back Panel Cover to the rear of your plate carrier, or to whatever piece of equipment you plan to conceal. Once attached begin applying the predator dreads by taking the two prong ends and simply fold in half. Find the ” = ” laser cut slit shape and push the predator dread through. Once through simply tie into a knot. Attach all eight predator dreads so that break up is consistent for the most concealment.